2-Phase Separator in Dynamics Mode

[svidille]

Dear Dan and everybody,

Again Simone. Now, I´m testing the 2-phase separators. I am trying it fixing the flow in the inlet and pressure in the gas outlet and flow in the liquid. Not sure if this is a correct configuration. Normally, this configuration works well in other simulators, so I can be suggested to wrong configuration.

First, I calculate the separator in steady-state in order to get the flash and to know the flow of liquid in steady-state. The pressure should be the one pre-determined, as well as the inlet flow.

Later, I changed to dynamics mode and configured the separator (orientation, operating pressure, volume, height, liquid level) and make it 50% full of the inlet material.

Fixed the pressure in the gas and flow in the inlet and liquid outlet, as already said.

Once more, I am not getting good results. What are my mistakes in the configuration?

Besides, I missed a way to configure the nozzles heights and the static head contribution. How can access those options?

The last one in this message: I pressed View/Edit Accumulation Stream button inside the separator configurator and it does not open anything. Should I be able to see/configure something there?

Thanks again,
Simone
3.Tank-after-run - copia.zip