You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi there, I bought a PanelDue 7 and I want to use it with the Radds 1.5 and Repetier firmware. I connected it to the serial port and installed the current firmware 1.23.2 on the PanelDue. I have connections with the Radds, can control the printer (move, home, heat). The speed is too fast when move, the speed is correct when home. I think the printer runs at max. Speed that is stored in the Repetier firmware instead of the defined speed for move. Can you change it? Reprap firmware works with mm / min and Repetier with mm / sec. maybe that's where the mistake lies. The other problem is the SD card. I can access the SD card in the Radds, but I cannot start programs from it. The PanelDue jumps back to the start menu as soon as I start a program. After that, the printer can no longer be controlled; you have to switch it off and on again. The SD card slot on the PanelDue shows me no files from the SD card. I do not know if it is defective or the firmware from the PanelDue cannot. Is it possible to configure the firmware for the PanelDue so that it runs well with the Repetier firmware and programs can be played from the SD card slot on the PanelDue? Excuse my English, I'm using a translator.
The text was updated successfully, but these errors were encountered:
Hi there, I bought a PanelDue 7 and I want to use it with the Radds 1.5 and Repetier firmware. I connected it to the serial port and installed the current firmware 1.23.2 on the PanelDue. I have connections with the Radds, can control the printer (move, home, heat). The speed is too fast when move, the speed is correct when home. I think the printer runs at max. Speed that is stored in the Repetier firmware instead of the defined speed for move. Can you change it? Reprap firmware works with mm / min and Repetier with mm / sec. maybe that's where the mistake lies. The other problem is the SD card. I can access the SD card in the Radds, but I cannot start programs from it. The PanelDue jumps back to the start menu as soon as I start a program. After that, the printer can no longer be controlled; you have to switch it off and on again. The SD card slot on the PanelDue shows me no files from the SD card. I do not know if it is defective or the firmware from the PanelDue cannot. Is it possible to configure the firmware for the PanelDue so that it runs well with the Repetier firmware and programs can be played from the SD card slot on the PanelDue? Excuse my English, I'm using a translator.
The text was updated successfully, but these errors were encountered: