Problem with Bed Tilt going too far (245mm) on E3V2-UBL-BLTouch-10x10-v4.2.2-v2.0.1.bin firmware

[codemagi]

I have upgraded my Ender 3 V2 to linear rails with hard stops at 235mm and although all the UBL mesh points work fine without issue (skips points that would crash the head), when I do the bed tilt I get hard crashing on my X axis as the tilt is trying to hit 245mm. Not sure if this is standard or not but I like working at 230mm soft limit for the X to prevent the end stop crash. Wondering if I'm just misunderstanding an adjustment I need to make or if the firmware needs tweaking?