BLTouch with Z Stop Plug

[jonmdo]

I have 2 Ender 3 V2s, Updated to the new firmware today from smith3d's page, but one of my enders have the bltouch plugged into the zstop port because of issues I had before.

I cant find the updated build for that option

[haynesdavid]

It's in the comments in the config file. Z end stop pin.

[jonmdo]

sorry, im pretty new at messing with the firmware. i've been using precompiled firmware so i'm a little lost.

[mmithril]

I would also appreciate a pre-build firmware using z stop instead of pins in bltouch port.

I flashed 2.0.x.17 ZSwitchStop 5×5 Fast Smith3d Marlin Firmware from Smith3D section Sometimes Probe doesn’t finish during leveling but they stopped releasing own builds in favour of yours, just this one has no corresponding version in your project.