-
Notifications
You must be signed in to change notification settings - Fork 7
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Miele Ventilation Hood (DA3698) Fan not working #31
Comments
I need to look into this. I did not create the fan part and I am unable to test it without investing in a simulator since I do not have such a device. Will try to find a cause. |
Could you enable debug logging and paste the logging you see when switching the fan? |
That is very extensive logging. Thanks. I need some time to get to know the capabilities better and from the fan control. I see the author of the ventilation hood part of the plugin does the following: fanSpeed = (Number(value)/25).toFixed();
// Corrected formula to get right increments 25% = 1, 50% = 2, 75% = 3, 100% = 4 The delay I did not focus on yet, but it might be an unfortunate side effect of the hood reacting on the Miele cloud only every minute or so (at least low frequency) |
No matter what example i try it always gives similiar error to this The supported actions are: |
This is then most likely the problem the plugin also does not allow you to change the ventilation step. |
Power off {
"message": "Device with mieleDeviceId 000111097297 can't be powered off from its current state."
} Power on Light 1 {
"message": "Light command 'ENABLED (1)' is not available for device with mieleDeviceId 000111097297 and state 1 at this moment. Available light commands: List()"
} Light 2 {
"message": "Light command 'DISABLED (2)' is not available for device with mieleDeviceId 000111097297 and state 1 at this moment. Available light commands: List()"
} ventilationStep 1 {
"message": "Ventilation step of device with mieleDeviceId 000111097297 and state 1 cannot be changed to 1 at this moment. Available steps: List()"
} ventilationStep 2 {
"message": "Ventilation step of device with mieleDeviceId 000111097297 and state 2 cannot be changed to 1 at this moment. Available steps: List()"
} |
Model: DA3698
The control of lighting is possible, but the fan control does not work at all...
Any idea why that might be?
The text was updated successfully, but these errors were encountered: