Reset State / Manual set State

[chriopter]

Hey there!

I currently open a garage door by using a relay to use the official remote (shared garage). As a click on the remote is open in any case and the garage door closes automatically, I would like to reset the state so HomeKit always shows the Garage door as closed. Is there a possibility for that? My config is currently like that to trigger a relays for two doors (entrance / exit):

{
  "c":{
    "io":[[[12],2, 1, 1],[[3],2, 1, 1]] # Definiere GPIOs im High Status (12=Port, 2=Output Only, 1=Enable internal pull-up resistor, 1=Set GPIO output to HIGH value)
  },
  "a":[ # Garage 
{
    "t":40, #Entrance
    "d":1,
    "c":1, 
    "0":{"r":[[3,0,1]]},
    "1":{"r":[[3,0,1]]},
    "2":{"r":[[3,0,1]]},
    "3":{"r":[[3,0,1]]},
    "es": [ # Define Sub Services
        {
          "t": 40, # Garage Exit
          "d":1,
          "c":1,
          "0":{"r":[[12,0,1]]},
          "1":{"r":[[12,0,1]]},
          "2":{"r":[[12,0,1]]},
          "3":{"r":[[12,0,1]]}
        },
        {
          "t": 1, #  
          "0": { "r": [ [] ]}, # 
          "1": { "r": [ [] ], "s": [0] } # Reboot
        },
        {
          "t": 1,
          "0": { "r": [ [] ]},
          "1": { "r": [ [] ], "s": [1] } # Service
        },
        {
          "t": 1,
          "0": { "r": [ [] ]},
          "1": { "r": [ [] ], "s": [2] } # Search for OTA Update
        },
        {
          "t": 1,
          "0": { "r": [ [] ]},
          "1": { "r": [ [] ], "s": [3] } # Reconnect Wifi
        }
        ]
}
]
}