Feature blowing mode for hanging parts

[Goodfeat]

Hello.

Is it possible to add a function for blowinghanging parts.

Some parts can be printed without supports. However, in long sections of overhanging parts without supports, the plastic is twisted upward.

The program has a similar setting

But this setting only works on existing supports.
Is it possible to add a function for blowing hanging parts without support?

Thanks

[Ghostkeeper]

There is one, sort of. It's the Bridging Fan Speed setting. It's under Experimental, and can be seen once the extra bridging settings are enabled.

[Goodfeat]

Well, I will try it if I find it.
I just don’t use bridge setup

[Goodfeat]

Unfortunately this is not quite what I need
This setting only works at extreme angles.
when plastic is in the air

The program has two more settings

These settings are clearly related to the dangling elements.
Is it possible to add here the third setting for blowing the hanging elements?

[smartavionics]

If you install one of my Cura builds you get these settings...

You can find my builds at https://www.dropbox.com/sh/s43vqzmi4d2bqe2/AAADdYdSu9iwcKa0Knqgurm4a?dl=0. Please read the README.md there.

[Ghostkeeper]

Ah right, this is a duplicate of #6656 then. Please continue the discussion there!