forked from timvideos/litex-buildenv
-
Notifications
You must be signed in to change notification settings - Fork 1
Numato Opsis
Tim Ansell edited this page Sep 1, 2018
·
4 revisions
To use the Opsis, you need to set the jumpers correctly, connect cables correctly and then put the board into JTAG mode.
FIXME: Put something here about the Opsis.
The jumpers as set on the Opsis when it ships work.
FIXME: Put picture showing correct jumper configuration.
The programming computer must be connected to the USB-B port.
By default the Opsis will boot into HDMI2USB mode. To load gateware onto the board it must be switched into JTAG mode.
FIXME: Add instructions for switching the Opsis into JTAG mode.
-
HDMI2USB-mode-switch then run:
hdmi2usb-mode-switch --mode=jtag
-
Connect to console and use fx2 switch command.