SKR 1.3 pinout overlay

[Anarasha]

[fhollermayer]

Descriptions for the pins below the stepper drivers would be nice^^I was just recently searching for that information :)

[Anarasha]

Descriptions for the pins below the stepper drivers would be nice^^I was just recently searching for that information :)

You mean the ones literally under the drivers, between the two rows you plug the driver into? I'm not sure if those even have pinout names as they are primarily used to decide the steps for your drivers as far as I understand. I at least didn't see any pinout names on the diagram, but I could be wrong.
If anyone can clarify the pinout names of those I'll be happy to add it in

[fhollermayer]

The pin assignment should be as following:

red	red	black
MOT_MOSI	MS0	VDD
MOT_SCK	MS1	VDD
?-RX (CS)	MS2	VDD
MOT_MISO	RST/SLP	VDD

Where ? is [X, Y, Z, E0, E1] and VDD ist 3.3V

header	LPC1768
E1-RX	P1.1/ENET_TXD1
E0-RX	P1.8/ENET_CRS
Z-RX	P1.10/ENET_RXD1
Y-RX	P1.15/ENET_REF_CLK
X-RX	P1.17/ENET_MDIO
MOT_MISO	P0.5/I2SRX_WS/TD2/CAP2.1
MOT_SCK	P0.4/I2SRX_CLK/RD2/CAP2.0
MOT_MOSI	P4.28/RX_MCLK/MAT2.0/TXD3