You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When attempting to analyze uploaded files during heatup, I get a python TypeError in the logs, shown below. Assuming it is due to the printer's current temperature being reported with a decimal.
Issue is present on both version 1.6.1 and the latest 1.7.0rc1 of Octoprint, running version PrintTimeGenius version 2.2.8.
Hardware is a Pi 3b+, running an up-to-date octopi 0.18.0 installation, and python 3.7.3.
Failed to run '"/home/pi/oprint/bin/python3" "/home/pi/oprint/lib/python3.7/site-packages/octoprint_PrintTimeGenius/analyzers/analyze_progress.py" marlin-calc "/home/pi/.octoprint/uploads/REMOVED.gcode" ""'
Traceback (most recent call last):
File "/home/pi/oprint/lib/python3.7/site-packages/octoprint_PrintTimeGenius/__init__.py", line 329, in _do_analysis
if self._aborted and not _allow_analysis(self._plugin._printer, self._plugin._settings):
File "/home/pi/oprint/lib/python3.7/site-packages/octoprint_PrintTimeGenius/__init__.py", line 192, in _allow_analysis
if thermostat['actual'] < thermostat['target'] - 5:
TypeError: '<' not supported between instances of 'NoneType' and 'float'
I was able to resolve the issue myself by changing line 192 from if thermostat['actual'] < thermostat['target'] - 5: to if int(thermostat['actual']) < thermostat['target'] - 5: to convert the float to an integer. Not familiar enough with git to create a pull request unfortunately, and the change has only been tested with one file so far
The text was updated successfully, but these errors were encountered:
Very similar error, yes. It appears it may have something to do with the PSU Control plugin, it hasn't been calculating the print time for me since I set that up. Steps I took to recreate the error:
Removed & reinstalled PrintTimeGenius
Used 'Send to octoprint' in superslicer (fork of prusaslicer) with 'start printing after upload' checked. PSU control then turns on power to the printer, waits 15 seconds to connect, then beings the print automatically.
Did some more testing, attached the logs. With the file printeronandconnectedtest.gcode the plugin worked correctly, while the printer was powered on and connected. 2nd test, with the printer initially powered off, and powered on via PSU Control, and the file printerofftest.gcode I see the TypeError. Not sure what I did exactly by adding int( to line 192, I barely know python, just enough to "fix" an issue the completely wrong way
If I left something out of the logs below, let me know and I'll try and get you what you need.
When attempting to analyze uploaded files during heatup, I get a python TypeError in the logs, shown below. Assuming it is due to the printer's current temperature being reported with a decimal.
Issue is present on both version 1.6.1 and the latest 1.7.0rc1 of Octoprint, running version PrintTimeGenius version 2.2.8.
Hardware is a Pi 3b+, running an up-to-date octopi 0.18.0 installation, and python 3.7.3.
I was able to resolve the issue myself by changing line 192 from
if thermostat['actual'] < thermostat['target'] - 5:
toif int(thermostat['actual']) < thermostat['target'] - 5:
to convert the float to an integer. Not familiar enough with git to create a pull request unfortunately, and the change has only been tested with one file so farThe text was updated successfully, but these errors were encountered: