iNav - Matek 765 board: I have no servo outputs. I ruled out the common setup errors. Please review my CLI output? #10188
Replies: 1 comment 3 replies
-
|
First, on the Receiver tab of Configurator,.if you check one channel at a time, does each channel move correctly on the Receiver tab? |
Beta Was this translation helpful? Give feedback.
-
|
Hi Sensi, yup, the channels do move properly. I am using CRSF, so I had to select the correct type of TX. But each channel responds correctly (throttle is throttle, roll is roll, etc.) to my controller inputs. Also, when I unplug the board from the computer and arm it, I can move the throttle up and down- the motor responds like it should. I get absolutely nothing from the servos. |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
|
Have you checked that the servo outputs have power? |
Beta Was this translation helpful? Give feedback.
-
Hi there!
I need help getting my board to control the servos. I've checked for setup errors, ensured the output is turned on, and verified that the motor runs. However, I'm still waiting for a response from the servos. I get nothing. I played around with different mode setups, etc.
I'm starting to suspect it could be a hardware issue, such as a faulty board or soldering problems.
As I've been out of the hobby for a while, I'm open to the possibility of making a setup error. I've included the CLI output for your review. I'm eager to learn and improve, so could you please help me figure this out?
INAV_7.1.2_cli_20240701_105816.txt
Beta Was this translation helpful? Give feedback.
All reactions