SpeedyBee35 - the OSD is not showing after switch to iNAV

[AerialSimonH78]

I have a SpeedyBee35 it was flying on Betaflight all ok - but have just switched over the iNAV 7.1.2 on it all setup and works apart from I have no OSD showing! - Its analog works perfectly just flashed the iNAV and went through the settings - what should I check or missed??

[sensei-hacker]

First thing to check - did you configure and turn on the OSD?

[daijoubu]

Did you upload the Inav font?

[CorvusMonitoring]

I have the same problem here.
Concerning the Inav font, it seems that they are not accepted by the board: When I upload them, then reboot, the configartion panel shows old fonts again, as if I did not changed them.

[MrD-RC]

The font upload in configurator is for analogue only.

Please make sure you have set up the HD correctly. It is not the same as BetaFlight. https://youtu.be/elq6AF5gdXE

[CorvusMonitoring]

Oooh yes, i set it up correctly, following dozen of tutorials and advices.
it is not a config issue…

[CorvusMonitoring]

Can I precise that there is already a bug about that board, as the UART2 does not appear on the ports tab.
I switched to different ports on the board, no results, and different power supply (as suggested n another topic), no results.