reader.ino

#include "Arduino.h"
#include "OBD9141.h"

#define RX_PIN 0
#define TX_PIN 1
#define EN_PIN 2


OBD9141 obd;


void setup(){
    Serial.begin(9600);
    delay(2000);

    pinMode(EN_PIN, OUTPUT);
    digitalWrite(EN_PIN, HIGH);

    obd.begin(Serial1, RX_PIN, TX_PIN);

}
    
void loop(){
    Serial.println("Looping");

    bool init_success =  obd.init();
    Serial.print("init_success:");
    Serial.println(init_success);

    //init_success = true;
    // Uncomment this line if you use the simulator to force the init to be
    // interpreted as successful. With an actual ECU; be sure that the init is 
    // succesful before trying to request PID's.

    if (init_success){
        bool res;
        while(1){
            res = obd.getCurrentPID(0x11, 1);
            if (res){
                Serial.print("Result 0x11 (throttle): ");
                Serial.println(obd.readUint8());
            }
            
            res = obd.getCurrentPID(0x0C, 2);
            if (res){
                Serial.print("Result 0x0C (RPM): ");
                Serial.println(obd.readUint16()/4);
            }


            res = obd.getCurrentPID(0x0D, 1);
            if (res){
                Serial.print("Result 0x0D (speed): ");
                Serial.println(obd.readUint8());
            }
            Serial.println();

            delay(200);
        }
        delay(200);
    }
    delay(3000);
}