You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
On node screen, by default it shows all nodes detected by Lora and MQTT. However, the filters by default are on for Lora and online, which isn’t being shown. Changing the filters to only show Lora and online only works, but if you go off node screen and say to the Bluetooth screen and back to node screen, the filters are not remembered and again reset.
Expected Behavior
The filters set should be remembered next time you go to node screen.
Current Behavior
See above
Participation
I am willing to submit a pull request for this issue.
Additional comments
No response
The text was updated successfully, but these errors were encountered:
They definitely do not stay the same within my single session. I can go from nodes to Bluetooth and back and the filters are changed or at least what is displayed.
Firmware Version
2.4.0
What did you do?
On node screen, by default it shows all nodes detected by Lora and MQTT. However, the filters by default are on for Lora and online, which isn’t being shown. Changing the filters to only show Lora and online only works, but if you go off node screen and say to the Bluetooth screen and back to node screen, the filters are not remembered and again reset.
Expected Behavior
The filters set should be remembered next time you go to node screen.
Current Behavior
See above
Participation
Additional comments
No response
The text was updated successfully, but these errors were encountered: