Hot End Temps

[Pridanc]

Miguel, all,
As I have an all metal hot-end on my E3-V2, there have been two times I thought I might print at higher temps than 260c (the current limit permitted by the firmware) but can't. I'm on the MSROC firmware 2.13.

Is there a line in the Marlin Firmware G-Code that I can use to address this? Is it as simple as changing this line in Marlin?
#define HEATER_0_MAXTEMP 275

Hate to be the ignorant one but I am holding my hand up...I'm that person.
Thanks in advance, PDC

[mriscoc]

Look for C104 custom G-code, there is a video in the videos section of the Wiki. In short you need to write something like:

C104 U1 T315

For reach a working temperature of 300°C but be careful.

[Pridanc]

Miguel,
Many thanks for the information. Also thanks for the warning to be careful. As an ex car racer I can say I'm very careful! Stay well, PDC