Runout sensor issue
#1367
Replies: 1 comment
-
|
So after careful reading I realized that triggered is not the state that stops the print - open does that. Can disregard initial post. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Just installed Ender3V2-427-BLTUBL-MPC-20240125.bin. I have enabled the runout sensor and checked the end stop diagnostics and can toggle the runout sensor status. However when it is in triggered state is does not stop the print.
Beta Was this translation helpful? Give feedback.
All reactions