bom_replace_hellen154hyundai-c.csv

# remove the jumper connection from VCC_PP1 to +5V: we need +12v power supply for push-pull outputs.
R309,

# remove +5V pull-ups from SPI1, because we use it with +3.3v accelerometer
R103,
R105,

# remove jumper resistor connecting BOOT1 with A22 input line, because we use STM32F4
R131,


# STM32
U105,"STM32F427ZGT6","LQFP144","C117816"
# clock crystal
Y101,"SC-20S,32.768kHz,20PPM,7pF","2012","C97602"

# LMR14020->LMR14030 (more power, no problem)
U420,"LMR14030","SOP8","C182078"

#power distribution
U103,"AP2331W-7","SOT-23","C460346"
U480,"AP2331W-7","SOT-23","C460346"

# DC-DC Inductor
L421,"MWSA0503S-100MT","SMD-5.2x5.4x2.8","C408412"
L420,"LBC3225T2R2MR","1210","C223413"

# being cheap since no code for accelerometer
U1,

#fuses
F1,"Fuse-5A-1206","F1206","C553924"
F410,"nSMD050-24V","F1206","C70076"
F300,"nSMD050-24V","F1206","C70076"

#INJ low-side
Q305,NCV8440ASTT3G,"SOT-223",C604063
Q306,NCV8440ASTT3G,"SOT-223",C604063
Q307,NCV8440ASTT3G,"SOT-223",C604063
Q308,NCV8440ASTT3G,"SOT-223",C604063
Q309,NCV8440ASTT3G,"SOT-223",C604063
Q310,NCV8440ASTT3G,"SOT-223",C604063
Q311,NCV8440ASTT3G,"SOT-223",C604063
Q312,NCV8440ASTT3G,"SOT-223",C604063

#ETB driver
# using substitution TLE9201SG
U6,"IFX9201SG","Infineon_PG-DSO-12-11","C112633"
U7,"IFX9201SG","Infineon_PG-DSO-12-11","C112633"

#pressure sensor
U4,"LPS22HBTR","HLGA-10L","C94049"


#non-JLC components
#IGBT
Q1,
Q2,
Q3,
Q4,
#main connector
P1,

# knock audio never used
J25,
# SD break-out not needed
J3,
# hit the case just a bit
P480,
# something not needed
J39,

#include hellen-one/board_id/generated/board_id_154hyundai-c.csv