Replies: 2 comments 6 replies
-
That should not be the case anymore. I should update the manual if that's where you found it. Maybe true if you have an old version of FW. If it's the access point "layzspaXXXXX" you can't reach it may also be a later version with a bug that would make it difficult to connect. Do you know what FW version you have? You can upload new FW yourself by following the manual, if that's the problem. |
Beta Was this translation helpful? Give feedback.
-
I think I might have found the solution, I understand networking a little but im certainly no expert. Instead of using the lazyspa.local if I login using the ip address it seems to work for now and it hasn't disconnected. |
Beta Was this translation helpful? Give feedback.
-
Ok so I have hooked everything up and it all seems to connect and work perfect for a few minutes or so and then just hangs. I have checked the signal which is pretty good and the pump is only about 5 metres away from the access point in direct sight. I have gone through the setup instructions and noticed the following info but I dont know how to implement it, is it something that can be done over wifi if I have a signal for a few minutes? I purchased the module complete so I did not make it up myself of programme it.
Device hangs if WiFi is bad
If not connected to WiFi the device will go into Access point mode and wait for you to enter your credentials. To avoid this,
edit file "config.h" and set bool enableAp = false;
Thanks
Mark
Beta Was this translation helpful? Give feedback.
All reactions