Skip to content
/ PiFan Public

Raspberry Pi CPU fan software control for 3 wire or 4 wire fans.

License

Notifications You must be signed in to change notification settings

MrBiz/PiFan

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

23 Commits
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

PiFan

V1.0

Raspberry Pi CPU fan software control for 3 wire (with controller) or 4 wire fans (without controller).

This is a Pulse Width Modulation (PWM) fan controller for load and temperature monitored fan control for the Raspberry Pi.
Note: this may work with 2 wire fans (with controller) but it won't have RPM monitoring. I haven't tested that setup yet though.

Installation:

  1. Copy all files to: /usr/local/sbin/fan/

  2. Run 'sudo chmod 755 /usr/local/sbin/fan/*'

  3. Copy file 'cpufan' to /etc/init.d/

  4. Run the command 'sudo update-rc.d cpufan defaults' to install the service.

The defaults should work but if you need to, you can change the settings in the configuration file 'fan.config'

Install your heatsink on the Raspberry Pi CPU Mount your fan on the top of your heatsink

Controller:

You will need:

  • A 5 volt 3 wire fan.
  • An NPN transister: I used a BC549C - Bipolar (BJT) Single Transistor, NPN, 30 V, 250 MHz, 625 mW, 100 mA, 500 hFE

I used this 30v one because it was the smallest I could get at the time, best practice is to use a resister between the transisters Base & GPIO14 (pin 8) as well but mine has been going for over a year without one and no issues so 'meh'.

  • Connect the red fan wire to GPIO5V (pin 4)

  • Connect the yellow fan wire (RPM Sensor) to GPIO15 (pin 10)

  • Connect the black fan wire to the Transisters collector (C)

  • Connect the Transisters Emmitter (E) to GPIOGround (pin 6)

  • Connect the Transisters Base (B) to GPIO14 (pin 8)

See 'ControllerDiag.png' for example

If all is good you should should hear the fan run up to full speed for about 2 seconds on boot, then it will slow as the service takes control.

As always, use at your own risk, no liability accepted, etc.

MrBiz.

About

Raspberry Pi CPU fan software control for 3 wire or 4 wire fans.

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published