Add config for the ARC Accessibility Controller (OpenStickCommunity#997)

This PR adds a config for the ARC Accessibility Controller

.github/workflows/cmake.yml

@@ -23,7 +23,7 @@ jobs:
     runs-on: ubuntu-latest
     strategy:
       matrix:
-        GP2040_BOARDCONFIG: [Pico, PicoW, BentoBox, FightboardV3, FightboardV3Mirrored, FlatboxRev4, FlatboxRev5, FlatboxRev5RGB, FlatboxRev5Southpaw, Granola, KB2040, KeyboardConverter, Haute42COSMOX, Liatris, Mavercade, OpenCore0, OpenCore0WASD, PicoAnn, PicoFightingBoard, RanaTadpole, ReflexCtrlGenesis6, ReflexCtrlNES, ReflexCtrlSaturn, ReflexCtrlSNES, ReflexCtrlVB, ReflexEncodeV1.2, ReflexEncodeV2.0, RP2040AdvancedBreakoutBoard, RP2040AdvancedBreakoutBoardUSBPassthrough, RP2040MiniBreakoutBoard, SparkFunProMicro, WaveshareZero, Stress, SGFBridget, SGFFaust]
+        GP2040_BOARDCONFIG: [ARCController, Pico, PicoW, BentoBox, FightboardV3, FightboardV3Mirrored, FlatboxRev4, FlatboxRev5, FlatboxRev5RGB, FlatboxRev5Southpaw, Granola, KB2040, KeyboardConverter, Haute42COSMOX, Liatris, Mavercade, OpenCore0, OpenCore0WASD, PicoAnn, PicoFightingBoard, RanaTadpole, ReflexCtrlGenesis6, ReflexCtrlNES, ReflexCtrlSaturn, ReflexCtrlSNES, ReflexCtrlVB, ReflexEncodeV1.2, ReflexEncodeV2.0, RP2040AdvancedBreakoutBoard, RP2040AdvancedBreakoutBoardUSBPassthrough, RP2040MiniBreakoutBoard, SparkFunProMicro, WaveshareZero, Stress, SGFBridget, SGFFaust]
 
     steps:
     #Global Setup

configs/ARCController/ARCController.h

@@ -0,0 +1,48 @@
+/*
+ * Copyright (c) 2020 Raspberry Pi (Trading) Ltd.
+ *
+ * SPDX-License-Identifier: BSD-3-Clause
+ */
+
+// -----------------------------------------------------
+// NOTE: THIS HEADER IS ALSO INCLUDED BY ASSEMBLER SO
+//       SHOULD ONLY CONSIST OF PREPROCESSOR DIRECTIVES
+// -----------------------------------------------------
+
+
+#ifndef _BOARDS_ARCCONTROLLER_H
+#define _BOARDS_ARCCONTROLLER_H
+
+// For board detection
+#define ARCCONTROLLER
+
+//For crappy crystal
+#ifndef PICO_XOSC_STARTUP_DELAY_MULTIPLIER
+#define PICO_XOSC_STARTUP_DELAY_MULTIPLIER 64
+#endif
+
+// --- LED ---
+#ifndef PICO_DEFAULT_LED_PIN
+#define PICO_DEFAULT_LED_PIN 25
+#endif
+// no PICO_DEFAULT_WS2812_PIN
+
+// --- FLASH ---
+#define PICO_BOOT_STAGE2_CHOOSE_W25Q080 1
+
+#ifndef PICO_FLASH_SPI_CLKDIV
+#define PICO_FLASH_SPI_CLKDIV 2
+#endif
+
+#ifndef PICO_FLASH_SIZE_BYTES
+#define PICO_FLASH_SIZE_BYTES (2 * 1024 * 1024)
+#endif
+
+// Drive high to force power supply into PWM mode (lower ripple on 3V3 at light loads)
+#define PICO_SMPS_MODE_PIN 23
+
+#ifndef PICO_RP2040_B0_SUPPORTED
+#define PICO_RP2040_B0_SUPPORTED 1
+#endif
+
+#endif

configs/ARCController/BoardConfig.h

@@ -0,0 +1,97 @@
+/*
+ * SPDX-License-Identifier: MIT
+ * SPDX-FileCopyrightText: Copyright (c) 2024 OpenStickCommunity (gp2040-ce.info)
+ */
+
+#ifndef PICO_BOARD_CONFIG_H_
+#define PICO_BOARD_CONFIG_H_
+
+#include "enums.pb.h"
+#include "class/hid/hid.h"
+
+#define BOARD_CONFIG_LABEL "ARC Accessibility Controller"
+
+// Main pin mapping Configuration
+//                                                  // GP2040 | Xinput | Switch  | PS3/4/5  | Dinput | Arcade |
+#define GPIO_PIN_02 GpioAction::BUTTON_PRESS_UP     // UP     | UP     | UP      | UP       | UP     | UP     |
+#define GPIO_PIN_03 GpioAction::BUTTON_PRESS_DOWN   // DOWN   | DOWN   | DOWN    | DOWN     | DOWN   | DOWN   |
+#define GPIO_PIN_04 GpioAction::BUTTON_PRESS_LEFT   // LEFT   | LEFT   | LEFT    | LEFT     | LEFT   | LEFT   |
+#define GPIO_PIN_05 GpioAction::BUTTON_PRESS_RIGHT  // RIGHT  | RIGHT  | RIGHT   | RIGHT    | RIGHT  | RIGHT  |
+#define GPIO_PIN_06 GpioAction::BUTTON_PRESS_B3     // B3     | X      | Y       | Square   | 1      | P1     |
+#define GPIO_PIN_07 GpioAction::BUTTON_PRESS_B4     // B4     | Y      | X       | Triangle | 4      | P2     |
+#define GPIO_PIN_08 GpioAction::BUTTON_PRESS_R1     // R1     | RB     | R       | R1       | 6      | P3     |
+#define GPIO_PIN_09 GpioAction::BUTTON_PRESS_L1     // L1     | LB     | L       | L1       | 5      | P4     |
+#define GPIO_PIN_10 GpioAction::BUTTON_PRESS_B1     // B1     | A      | B       | Cross    | 2      | K1     |
+#define GPIO_PIN_11 GpioAction::BUTTON_PRESS_B2     // B2     | B      | A       | Circle   | 3      | K2     |
+#define GPIO_PIN_12 GpioAction::BUTTON_PRESS_R2     // R2     | RT     | ZR      | R2       | 8      | K3     |
+#define GPIO_PIN_13 GpioAction::BUTTON_PRESS_L2     // L2     | LT     | ZL      | L2       | 7      | K4     |
+#define GPIO_PIN_14 GpioAction::BUTTON_PRESS_S1     // S1     | Back   | Minus   | Select   | 9      | Coin   |
+#define GPIO_PIN_15 GpioAction::BUTTON_PRESS_S2     // S2     | Start  | Plus    | Start    | 10     | Start  |
+#define GPIO_PIN_16 GpioAction::BUTTON_PRESS_A1     // A1     | Guide  | Home    | PS       | 13     | ~      |
+#define GPIO_PIN_17 GpioAction::BUTTON_PRESS_A2     // A2     | ~      | Capture | ~        | 14     | ~      |
+#define GPIO_PIN_18 GpioAction::BUTTON_PRESS_L3     // L3     | LS     | LS      | L3       | 11     | LS     |
+#define GPIO_PIN_19 GpioAction::BUTTON_PRESS_R3     // R3     | RS     | RS      | R3       | 12     | RS     |
+
+
+// Setting GPIO pins to assigned by add-on
+//
+#define GPIO_PIN_00 GpioAction::ASSIGNED_TO_ADDON
+#define GPIO_PIN_01 GpioAction::ASSIGNED_TO_ADDON
+#define GPIO_PIN_22 GpioAction::ASSIGNED_TO_ADDON
+#define GPIO_PIN_20 GpioAction::ASSIGNED_TO_ADDON
+#define GPIO_PIN_21 GpioAction::ASSIGNED_TO_ADDON
+
+// Keyboard Mapping Configuration
+//                                            // GP2040 | Xinput | Switch  | PS3/4/5  | Dinput | Arcade |
+#define KEY_DPAD_UP     HID_KEY_ARROW_UP      // UP     | UP     | UP      | UP       | UP     | UP     |
+#define KEY_DPAD_DOWN   HID_KEY_ARROW_DOWN    // DOWN   | DOWN   | DOWN    | DOWN     | DOWN   | DOWN   |
+#define KEY_DPAD_RIGHT  HID_KEY_ARROW_RIGHT   // RIGHT  | RIGHT  | RIGHT   | RIGHT    | RIGHT  | RIGHT  |
+#define KEY_DPAD_LEFT   HID_KEY_ARROW_LEFT    // LEFT   | LEFT   | LEFT    | LEFT     | LEFT   | LEFT   |
+#define KEY_BUTTON_B1   HID_KEY_SHIFT_LEFT    // B1     | A      | B       | Cross    | 2      | K1     |
+#define KEY_BUTTON_B2   HID_KEY_Z             // B2     | B      | A       | Circle   | 3      | K2     |
+#define KEY_BUTTON_R2   HID_KEY_X             // R2     | RT     | ZR      | R2       | 8      | K3     |
+#define KEY_BUTTON_L2   HID_KEY_V             // L2     | LT     | ZL      | L2       | 7      | K4     |
+#define KEY_BUTTON_B3   HID_KEY_CONTROL_LEFT  // B3     | X      | Y       | Square   | 1      | P1     |
+#define KEY_BUTTON_B4   HID_KEY_ALT_LEFT      // B4     | Y      | X       | Triangle | 4      | P2     |
+#define KEY_BUTTON_R1   HID_KEY_SPACE         // R1     | RB     | R       | R1       | 6      | P3     |
+#define KEY_BUTTON_L1   HID_KEY_C             // L1     | LB     | L       | L1       | 5      | P4     |
+#define KEY_BUTTON_S1   HID_KEY_5             // S1     | Back   | Minus   | Select   | 9      | Coin   |
+#define KEY_BUTTON_S2   HID_KEY_1             // S2     | Start  | Plus    | Start    | 10     | Start  |
+#define KEY_BUTTON_L3   HID_KEY_EQUAL         // L3     | LS     | LS      | L3       | 11     | LS     |
+#define KEY_BUTTON_R3   HID_KEY_MINUS         // R3     | RS     | RS      | R3       | 12     | RS     |
+#define KEY_BUTTON_A1   HID_KEY_9             // A1     | Guide  | Home    | PS       | 13     | ~      |
+#define KEY_BUTTON_A2   HID_KEY_F2            // A2     | ~      | Capture | ~        | 14     | ~      |
+#define KEY_BUTTON_FN   -1                    // Hotkey Function                                        |
+
+#define BOARD_LEDS_PIN 22
+
+#define LED_BRIGHTNESS_MAXIMUM 50
+
+#define LEDS_DPAD_LEFT   0
+#define LEDS_DPAD_DOWN   1
+#define LEDS_DPAD_RIGHT  2
+#define LEDS_DPAD_UP     3
+#define LEDS_BUTTON_B3   4
+#define LEDS_BUTTON_B4   5
+#define LEDS_BUTTON_R1   6
+#define LEDS_BUTTON_L1   7
+#define LEDS_BUTTON_B1   8
+#define LEDS_BUTTON_B2   9
+#define LEDS_BUTTON_R2   10
+#define LEDS_BUTTON_L2   11
+
+#define HAS_I2C_DISPLAY 1
+#define I2C0_ENABLED 1
+#define I2C0_PIN_SDA 0
+#define I2C0_PIN_SCL 1
+#define DISPLAY_I2C_BLOCK i2c0
+#define DISPLAY_FLIP 1
+
+#define USB_PERIPHERAL_ENABLED 1
+#define USB_PERIPHERAL_PIN_DPLUS 20
+
+#define DEFAULT_INPUT_MODE_R1 INPUT_MODE_XBONE
+#define DEFAULT_INPUT_MODE_B4 INPUT_MODE_PS5
+#define DEFAULT_PS5AUTHENTICATION_TYPE INPUT_MODE_AUTH_TYPE_USB
+
+#endif

configs/ARCController/README.md

@@ -0,0 +1,7 @@
+# GP2040 Configuration for the ARC Accessibility Controller
+
+![ARC Accessibility Controller](assets/ARC%20Accessibility%20Controller%201.JPG)
+
+Basic pin setup for the ARC Accessibility Controller.
+
+![Pin Mapping](assets/ARC%20Accessibility%20Controller%20-%20Pin%20Mapping.JPG)