-
-
Notifications
You must be signed in to change notification settings - Fork 109
Technogym MyRun Howto Auto Inclination
Reference: https://youtu.be/q7OtkN9EjtU
General
Zwift currently does not send commands to a treadmill in Run mode. If, on the other hand, the Ride mode is used, Zwift sends commands to the training device. If you switch to a Run Meetup during a Ride session, Zwift continues sending the incline to the training device, among other things. QZ takes advantage of this fact.
So, to perform a Run with auto-incline (via QZ), you must first create a Run Meetup (contaning your desired route and start time), then start a Ride and join your Run Meetup.
Remember
Doing a Workout in a Meetup is possible, but most workouts use a 0% inclination - no matter what the inclination of the current section is.
The best use of QZ (Auto-incline) is in Free-Run Meetup's.
Some information about the cadence supported by MyRun
Info from Technogym Italy, Cadence is displayed correctly up to 9 km/h.
Best Regards
Technical Call Center Dept
Needed:
- MyRun treadmill (tested with MyRun Firmware BA30.30-CA30.12)
- Android/iOS Device with QZ
- Android/iOS Device, AppleTV, PC or Mac with Zwift
- Created and joined Zwift Run Meetup (Create Meetup with Zwift Companion App - Events)
Do next steps some minutes (min. 3 minutes) before Run Meetup starts.
Starting MyRun with QZ:
- MyRun is powered on
- Place Phone/Tablet with QZ (not running) on MyRun in either location.
- MyRun wakes up (MyRun start button: green)
- Launch QZ
- QZ automatically connects to MyRun with QZ Paused - Start/Pause button on QZ blinking red, Myrun belt not moving.
- Press the MyRun start button to begin run.
Starting Zwift Run on Zwift device:
- Start Zwift
- Login
- Select bike - connect power, cadence and controlable with your QZ device
- Start any route
- Bike should now slowly move and incline may rise
- Join your Run Meetup
- When you are in your Run Meetup goto Menu and connect speed with your QZ device
- Done
- Now wait for Meetup begin...