How to use rvx builder on Android

How to install rvx-builder for the first time

1. Firstly, you have to install Termux. To do this, you have to install F-Droid.

2. After that, you have to run these commands:

curl -sLo rvx-builder.sh https://raw.githubusercontent.com/inotia00/rvx-builder/revanced-extended/android-interface.sh && chmod +x rvx-builder.sh && ./rvx-builder.sh

※ If an error occurs, enter it line by line:

curl -sLo rvx-builder.sh https://raw.githubusercontent.com/inotia00/rvx-builder/revanced-extended/android-interface.sh

chmod +x rvx-builder.sh

./rvx-builder.sh

※ During initial installation, termux will ask if you want to update additional packages. (Enter Y or N.)

3. After installing, rvx-builder will run automatically!

Run command

When to run rvx-builder in termux, just type these commands:

./rvx-builder.sh run

or

rvx

Update command

If there is an update of rvx-builder, just type these commands:

./rvx-builder.sh update && ./rvx-builder.sh run

or

rvxup

Reinstall command

When an issue occurs so you need to reinstall rvx-builder, just type these commands:

./rvx-builder.sh reinstall && ./rvx-builder.sh run

or

rvxre

Troubleshooting

1. If you get an error when installing rvx-builder for the first time

• Check if termux is downloaded from F-Droid.
• Try reinstalling termux
• Try changing vpn/dns
• Try entering the following command:

apt-get autoremove nodejs-lts -y && pkg install nodejs-lts -y && apt-get autoremove openjdk-17 -y && pkg install openjdk-17 -y && ./rvx-builder.sh run

2. If you used rvx-builder without issues before, but the issue occurred while using it again

• reinstall rvx-builder:

./rvx-builder.sh reinstall && ./rvx-builder.sh run

3. If an issue occurs during the patching process

• Read the Common document again.
• Make sure termux has battery optimization exclusions.
• Make sure your device has arm64-v8a architecture. (Probably, other architectures are not supported.)
• reinstall rvx-builder:

./rvx-builder.sh reinstall && ./rvx-builder.sh run

or

rvxre

※ If you encounter any other issues, please report them on the github issues page.