🐍 💻 T-Display S3 - Clock + 3D Printer Status

This repository contains Micropython code for the LilyGO®️ T-Display S3 microcontroller, designed as a clock and 3D printer status monitor. It connects to a Klipper-controlled printer via the Moonraker API to check if the printer is on and display print progress if a job is active. Written entirely in Micropython, it offers a simple and effective way to monitor your 3D printer.

LilyGO.T-Display.S3.mp4

⬇️ Download

The code

First, clone this repository:

git clone https://github.com/julioformiga/t-display-clock-3d-printer

The firmware

Learn about and download the Micropython firmware with the embedded ST7789 driver from this repo:

https://github.com/russhughes/st7789s3_mpy

Download the firmware

wget https://github.com/russhughes/st7789s3_mpy/raw/main/firmware/firmware.bin

🧰 Configuration

Tools

I personally used the PDM package manager primarily to install esptool and mpremote.

With PDM installed, simply run:

pdm install
eval $(pdm venv activate)

Or with pipx:

pipx install esptool mpremote

Firmware

With the programs installed, the firmware.bin in your .firmware/ folder, and the T-Display connected via USB in boot mode, run the command to erase the flash:

esptool.py --port /dev/ttyACM0 erase_flash

esptool.py --port /dev/ttyACM0 write_flash 0 firmware/firmware.bin

Note1: change /dev/ttyACM0 for your USB device

Note2: It is recommended to use ... write_flash 0x1000 firmware/firmware.bin, but this didn't work for me.

Config Wifi e o IP da 3D printer

Edit the data in .src/config.py:

HOSTNAME = "ESP32-TDisplay"
IP_3D_PRINTER = "xxx.xxx.xxx.xxx"
WIFI_SSID = "YOUR-SSID"
WIFI_PASS = "YOUR-PASS"

⬆️ Upload

To upload the files to the T-Display S3 device, run the setup.sh script:

source setup.sh

🚧 WIP & OTC (Open To Collab 🤝😁)

It is unlikely to work with just these instructions due to different environments and operating systems.

If you encounter any difficulties, feel free to open an issue or get in touch.