Pairing your device

Overview

With enoceanmqtt, pairing is not required for unidirectional sensors.
As those sensors broadcast their data, enoceanmqtt is able to access and decode those data without requiring to be paired to the sensor.
Pairing is only needed when your device needs to be controlled from Home Assistant, typically actuators, lights, etc.

In addition, when pairing is required, it is automatically handled by enoceanmqtt through the Python EnOcean library.
Hence, except for some devices not fully supported for now, typically Eltako devices, you don't need to use DolphinView for pairing.

Procedure

When pairing is needed for your device, use the following procedure:

1. Follow the instructions of your device regarding pairing to put it in pairing mode.
2. Once your device is in pairing mode, go to Settings
3. → Devices & Services
4. → Under Mosquitto Broker click on xx devices
5. → Select the ENOCEANMQTT device
6. → Turn on the LEARN switch.
   The pairing response will be submitted automatically.
7. Turn off the LEARN switch once pairing is completed to avoid unwanted pairing with other devices.

Screenshots

Settings

Devices & Services

Under Mosquitto Broker click on xx devices

Select the ENOCEANMQTT device

Learn button