BTT SFS 2.0 filament sensor connection

[madspeed]

Can anyone help with firmware setup and wiring diagram to ender 3 v2 neo with 4.2.2 board?
The new BTT SFS 2.0 has two sensors - switch and motion, so 4 wires instead of 3.
My firmware is 2.1.3

[mriscoc]

This filament sensor requires a custom build and is not currently supported.
Maybe you can use it as a BTT Smart filament motion sensor connecting the +V, GND, and Motion out pins to the runout sensor connector.

[madspeed]

What is the best filament sensor, which is supported?
Thank you.

[mriscoc]

If you already buy that sensor, maybe you can use it as a BTT Smart filament motion sensor which is currently supported.

[madspeed]

I will try to connect it to octoprint via rpi gpio contacts. This method allows to connect several filament sensors.