-Wall to Bare wire adapter (Can just chop off from some other cord or device)
-Tie the positive wire from the outlet input to L on the power adapted, the neutral wire to N and the ground to the ground symbol
-Tie one of the red positive wire from the lights to the +V output on the adapter and the white negative wire to -V
-Solder the other red positive wire from the lights to VIN on the MCU, the white one to ground and the middle green data pin to RX (NOT TX)
-Select "Node MCU 1.0 (ESP-12 Module)" from tools->boards in the arduino IDE
-Open node.ino from the github project
-CHANGE SSID TO YOUR LOCAL NETWORK NAME AND PASS TO THE PASSWORD AT THE TOP OF NODE.INO
-Flash the file onto the MCU
-Run input.py play music and and watch the lights!