soundwire: qcom: adjust autoenumeration timeout

Currently timeout for autoenumeration during probe and bus reset is set to
2 secs which is really a big value. This can have an adverse effect on
boot time if the slave device is not ready/reset.
This was the case with wcd938x which was not reset yet but we spent 2
secs waiting in the soundwire controller probe. Reduce this time to
1/10 of Hz which should be good enough time to finish autoenumeration
if any slaves are available on the bus.

Reported-by: Srinivasa Rao Mandadapu <[email protected]>
Signed-off-by: Srinivas Kandagatla <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Vinod Koul <[email protected]>

drivers/soundwire/qcom.c

@@ -105,7 +105,7 @@
 
 #define SWRM_SPECIAL_CMD_ID	0xF
 #define MAX_FREQ_NUM		1
-#define TIMEOUT_MS		(2 * HZ)
+#define TIMEOUT_MS		100
 #define QCOM_SWRM_MAX_RD_LEN	0x1
 #define QCOM_SDW_MAX_PORTS	14
 #define DEFAULT_CLK_FREQ	9600000