[action] [PR:17768] [Arista] Update config.bcm of 7060_cx32s for handling 40g optics with unreliable los settings (#17768) #17996
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
For 40G optics there is SAI handling of T0 facing ports to be set with SR4 type and unreliable los set for a fixed set of ports. For this property to be invoked the requirement is set
phy_unlos_msft=1 in config.bcm.
This change is to meet the requirement and once this property is set, the los/interface type settings is applied by SAI on the required ports.
Why I did it
For Arista-7060CX-32S-Q32 T1, 40G ports RX_ERR minimalization during connected device reboot
can be achieved by turning on Unreliable LOS and SR4 media_type for all ports which are connected to T0.
The property phy_unlos_msft=1 is to exclusively enable this property.
Microsoft ADO: 25941176
How I did it
Changes in SAI and turning on property
How to verify it
Ran the changes on a testbed and verified configurations are as intended.
with property
admin@sonic2:~$ bcmcmd "phy diag xe8 dsc config" | grep -C 2 "LOS"
Brdfe_on = 0
Media Type = 2
Unreliable LOS = 1
Scrambling Disable = 0
Lane Config from PCS = 0
without property
admin@sonic:~$ bcmcmd "phy diag xe8 dsc config" | grep -C 2 "LOS"
Brdfe_on = 0
Media Type = 0
Unreliable LOS = 0
Scrambling Disable = 0
Lane Config from PCS = 0
Signed-off-by: vaibhav-dahiya [email protected]