Skip to content

TinyG Configuration

Jump to bottom Edit New page
Alden Hart edited this page Aug 19, 2014 · 165 revisions

This is a jump page for the version-specific configuration pages. Go to one of the following pages for configuration for your firmware version. You can find out the firmware version by entering $fv or by looking at the console output when you hit reset.

Getting Started Pages

  1. Home
  2. What is TinyG?
  3. Getting Started
  4. Connecting TinyG
  5. Configuring TinyG
  6. Sending Gcode Files
  7. Flashing TinyG
  8. Chilipeppr

Reference Pages

  1. TinyG Help Page
  2. TinyG Tuning
  3. TinyG Command Line
  4. TinyG JSON
  5. Gcode Support
  6. Homing and Limits
  7. Inch and MM Units
  8. Alarms and Exceptions
  9. Coordinate Systems
  10. Status Codes
  11. Status Reports
  12. Power Management
  13. Feedhold and Resume
  14. Licensing
  15. TinyG v8 Data Sheet

Discussion Topics

  1. Test-Drive-TinyG
  2. Jerk Controlled Motion
  3. Gcode Parsing
  4. Shapeoko Setup
  5. OX CNC TinyG Guide
  6. Creating Gcode Files
  7. Milling With Noisy Spindles
  8. Stepper Motors and Power Supplies
  9. Text Wrappers and Transaction IDs
  10. Using External Drivers
  11. TinyG Projects

Chilipeppr

  1. Chilipeppr
  2. Chilipeppr Advanced Usage
  3. Chilipeppr Archive and Restore Parameters
  4. ChiliPeppr PCB Auto Level
  5. Automatic Z Homing When Milling PCBs

Troubleshooting

  1. Troubleshooting
  2. SpDir Continues To Flash Error

Developer Pages

  1. Introduction to the TinyG Code Base
  2. TinyG-Developer-Notes
  3. Project-Setup-For-Atmel-Studio6.2
  4. Continuous-Delivery-Process
  5. Git Notes
  6. TinyG-State-Model
Clone this wiki locally